S8910U1000 Universal Hot Surface Ignition Module

Replaces over 650 White-Rodgers, Robertshaw and Honeywell hot surface ignition models.

For 120 Vac (up to 5.0A) surface igniter (Norton 201/271 or equivalent).

For local (single rod) or remote (dual rod) rectification type flame sensing.

Contains easy-to-use cross reference and instructions plus the accessories required to replace the existing hot surface ignition module.

Provides one or three ignition trials (four-second or seven-second trials) per call for heat.

Field selectable number of ignition trials and trial time based on unit being replaced.

Dimensions (in.): 5 1/4 in. high x 4 1/16 in. wide x 1 15/16 in. long

Dimensions (mm): 133 mm high x 103 mm wide x 49 mm deep

Electrical Ratings: 24 Vac

Frequency: 60 Hz

Approvals, Canadian Standards Association: Design Certified

Tradeline Value: Tradeline

Flame Failure Response Time (sec) : 1.5 sec.

PrePurge : 32 seconds

Ambient Temperature Range (F) : -40 F to +175 F

Ambient Temperature Range (C): -40 C to +79 C

Ignition System Type : Direct Hot Surface Ignition

Typical Gas Control : VR8205, VR8305

Type of Gas: Natural or LP

Flame Sense: Single Rod or Two Rods

Ignition Source : Line Voltage (120 VAC) Hot Surface Element (Norton Model 201 or 270)

Ignition Trials To Lockout : 1 or 3

Lockout Timing: 4 sec. or 7 sec.

Ignition Trial Time (sec): 4 sec. or 7 sec.

Maximum Valve Load @ 24 Vac (Amps): 2A

Typical Ignition Hardware: Norton 201, Norton 271, Q354

Between Trial Time (sec): (2) 96 sec.- 3 trial mode only